0%
VLTZ Flex Pods are designed for use with the VLTZ Flex Pod Kit. They are pre-filled with 2ml of 16mg (1.6%) Nicotine Salt and aim to give you the same experience you would get when vaping disposables. The slightly lower nicotine strength, to the 20mg normally found in disposables, is because of the slightly higher power of this device so the end result will be very similar.
No need to refill the pods or replace the coils! Once you finish a pod, just pop a new one in and you are good to go. Each pod should last you around 600 puffs or around 1 day of vaping. Using VLTZ Flex Pods will help you save money and reduce the amount of waste normally created by disposable vapes.
The Aspire K3 Glassomizer is a 2ml capacity tank which is designed to be used in the mouth to lung style of vaping. It uses the Aspire Nautilus BVC replacement coils with a resistance of either 0.7, 1.6 or 1.8 ohms. Which coils fit the Aspire K3 Glassomizer? The coils compatible with the Aspire K3 […]
The original coils for the Cloudflask Pod and Cloudflask S Pod are the Aspire Cloudflask Replacement Coils. The Aspire Cloudflask Coil, which produces a lot of clouds, has well-designed mesh heating elements for pleasant DTL and restricted DTL vaping. It comes in 0.25ohm and 0.6ohm mesh coil sizes.
The newest ISub Clapton BVC coils from Innokin have a resistance of 0.5 ohm and are made of a base wire with a smaller gauge of wire wrapped around it to increase surface area and boost vapor and flavor production. They are recommended for use at 30 to 70 watts. Compatible with the Isub, Isub G, Isub V, Apex, and Isub S tanks; 5 pieces per pack.
HorizonTech’s Sakerz Coils look like regular pod kit coils however, they harness some powerful mesh heating elements which allow for a full sub-ohm vaping experience. Available in 2 resistances and coil structures which gives you the option to pick your favourite one. They are pressure fit into the tank so all you have to do […]
Uwell’s Caliburn G3 Pods are available in two different resistances and come in boxes of 4. Only compatible with the Caliburn G3 Kit as they work hand in hand with the technology within the kit. Each pod features a built-in mesh coil which has been developed by Uwell to produce even more flavour and a better […]
The Geek vape A Series coils are suitable for the Geek vape Z MTL tank only. Never forget to prime fresh coils. Install the coil, add a few drops of vape juice, and wait five minutes before using. By doing this, you may prevent dry hits and coil burning by making sure the coil is wet.
Select at least 2 products
to compare
Reviews
There are no reviews yet.