0%
The Xlim V2 Pods by OXVA have a 2ml capacity and contain a pre-installed, non-replaceable coil which is available in 3 different resistances. You can pick and choose your ideal resistance based on the e-liquid you are using and the power that you want to vape at. Please check out the table below for a breakdown of which pod will suit you best.
To refill the pod, lift up the rubber seal located on the side of the pod, tilt the pod so that the fill port is facing up, fill 95% and finally replace the silicon plug. Easy as that!
Sold as a pack of 3.
| Pod Type | Wattage | Compatible Kits |
| V2 Mesh – 0.6Ω | 20-25W |
|
| V2 Mesh – 0.8Ω | 12-16W |
|
| V2 Mesh – 1.2Ω | 10-12W |
|
VLTZ Flex Pods are designed for use with the VLTZ Flex Pod Kit. They are pre-filled with 2ml of 16mg (1.6%) Nicotine Salt and aim to give you the same experience you would get when vaping disposables. The slightly lower nicotine strength, to the 20mg normally found in disposables, is because of the slightly higher […]
These are replacement coils for the Innokin iClear 20D clearomiser that was first shipped with the EZ.TC Starter Kit. These 316L, stainless steel coils can be used in Wattage mode, however, they are specially optimized for temperature-controlled vaping. You may swap out the coil heads for the iClear 20D as well without draining the e-liquid from the clearomiser. Coils for the iClear 20D are available with a 0.5 Ohm resistance.
Resa Prince, is a vaping device with a capacity of 7.5ml. This replacement part is specifically designed for the Resa Prince and is intended to replace the original glass bulb that came with the device. The replacement glass can be used if the original glass is broken or cracked,
AS3 Pods from Uwell are great pods for Mouth To Lung (MTL) vaping made to be used with the Caliburn A3S Pod Kit. They also fit the Caliburn A3 Pod Kit which makes them nice and versatile and allows you to customise your experience. With two resistances available, you can choose between 0.8Ω and 1.2Ω resistances. Each […]
Innokin I Sub Tank Replacement Coils are interchangeable with the iSub/iSub G tanks. The housing for the coil head is composed of stainless steel. For a fresher flavour and a smoother vaping experience, the replacement coils for the iSub Tank are made with Kanthal wire and come in 0.2- and 0.5-ohm resistance.
Go Z Tank is compatible with the Z-coil series, which are mesh coils that provide enhanced flavour and vapour production. The Go Z Tank also has a convenient top-fill design and adjustable airflow control for customizable vapour production.
Select at least 2 products
to compare
Reviews
There are no reviews yet.